How to Install E-2 Clips on Your RC Crawler

Quick Answer

To install E-2 clips on your RC crawler, align the clip with the mounting hole, press it in with a small flathead screwdriver or pliers, and ensure it seats fully to avoid losing the part during a run.

Step-by-Step E-2 Clip Installation

1. Gather Your Tools: You'll need a small flathead screwdriver or needle-nose pliers, and optionally a small hammer or mallet. Make sure your work area is well-lit so you can see the clip and the mounting hole clearly. Check that your tool tips are small enough to fit into the clip's eye without slipping.
2. Align the Clip with the Mounting Hole: Position the E-2 clip over the hole where it needs to be installed. The clip's legs should straddle the hole, and the looped end should face outward for easy removal later. If the clip is misaligned, pressing it can bend the legs; double-check alignment before applying force.
3. Press the Clip In: Using your flathead screwdriver or pliers, press the clip straight down until it snaps into place. You should feel or hear a small click when it seats correctly. If the clip doesn't seat fully, don't force it—remove and re-align it to avoid damaging the clip or the mounting hole.
4. Verify the Clip is Secure: Gently tug on the clip to ensure it is firmly seated. If it moves or comes out easily, repeat the installation process, checking for debris or damage in the hole. A properly installed clip should not wobble; if it does, consider replacing it with a fresh one from your spare pack.

Product Facts

• E-2 CLIP: The Incision E-2 Clip is a small hardware part offered by Vanquish Products for hobby use. Each package includes ten E-2 clips. Having a pack of ten means you can keep spares in your toolbox, so a lost clip won't end your day of crawling.